Details

Home> Details

WD-E series Constant cut-in explosion proof thermostats (with SPST plus an aux switch)

  • WD-E series Constant cut-in explosion proof thermostats (with SPST plus an aux switch)
WD-E series Constant cut-in explosion proof thermostats (with SPST plus an aux switch)
  • Share To
  • 商品详情

PRODUCT DESCRIPTION

    This series have forced OFF, forced ON and automatic defrosting functions. When dialed at different position, the cut-out temperature is different but the cut-in temperature is without change. They can be used as temperature controlling elements in household refrigeration appliances such as double door direct cooling refrigerators, freezers, water dispensors, etc.
 
 

BASIC TECHNICAL PARAMETERS

Available temperature range:-36~+15℃Adjustable temperature range: Max.25℃
Differential:
Min.8℃
Note:Manufactured on customer requests
Certifications:CQC,VDE,UL

 

 

Installation and use instructions:
1. Grounding method: Connected to the grounding metal parts of the equipment through the metal casing of the thermostat.
2. The thermostat shall be operated in a general indoor environment where the relative humidity of the air is not more than 90%, no corrosive gas, no flammable gas and conductive dust.
3. When the temperature controller is in contact with the temperature, the cover should be placed close to the heat-generating part of the controlled appliance, and the thermal surface of the cover should be coated with thermal grease or other similar heat-conducting medium.
4. When the temperature controller is exposed to liquid or steam, it is recommended to use a stainless steel cover and a reliable leak-proof measure to prevent liquid from seeping into the insulation of the thermostat.
5. It is not possible to collapse or deform the top of the cover to avoid changes in operating temperature or other properties.
6. Do not allow liquid to penetrate inside the thermostat! The housing must be protected from excessive forces to prevent cracking; the housing should be kept clean to prevent contamination of conductive materials to prevent short-circuit breakdown due to reduced insulation.
7. The terminal cannot be bent during use, otherwise the reliability of the electrical connection will be affected.

Previous
Next