Details

Home> Details

KSD314-V Series Automatic Reset Type Big Current Thermostat

  • KSD314-V Series Automatic Reset Type Big Current Thermostat
  • KSD314-V Series Automatic Reset Type Big Current Thermostat
  • KSD314-V Series Automatic Reset Type Big Current Thermostat
KSD314-V Series Automatic Reset Type Big Current Thermostat
  • Share To
  • 商品详情

PRODUCT DESCRIPTION

KSD314-V series is a single-pole single-throw (SPST) automatic reset type thermostat (contact can be normally closed or normally open), and the housing is made of high temperature resistant resin material with a maximum operating temperature of 180C. The pressure rating is basic insulation, and certain additional measures can be taken to achieve a reinforced insulation level. The standard load nature is purely resistive, providing micro-disconnection.

 
 

BASIC TECHNICAL PARAMETERS

Sub-series

Action type

Switch type

Rated current (resistive load)

Operating temperature OT.

KSD314-V

Auto reset

SPST、NC/NO

35A

30180°C(TUV30140°C(UL

KSD314-R & KSD314-R-C

Manual reset

SPST、NC

35A

40140°C

KSD314-N

SOD

SPST、NC

35A

40140°C

KSD314-T

PTC cutoff,Voltage maintain type

SPST、NC

35A

55140°C

KSD314-Q

Double functions-Auto reset and one shot type

SPST、NC

45A

30100°C

KSD314-F

(developing

SPDT type Auto reset

SPDT

25A

30140°C

KSD314-W

(developing

Auto reset with thermal compensation

SPST、NC

25A

30140°C

 
 

Tmax

 

OT:70°C

OT:71~180°C


14C(L)    170°C (S)

205°C (L)    235°C (S)


L: Long term   

S:Less than 15 min

 

DIMENSION OF THE MAIN BODY

tongbao

 

SAFETY CERTIFICATE

OT

Life cycles

400V 25A

250V 35A 

125V 35A

250V 25A

125V 25A

0~140°C

10,000

UL (operating)



30,000


UL (operating)


60,000


TUV


100,000



UL (protective)

0~180°C

10,000

TUV



100,000



TUV

 

 

INSTALLATION AND DIRECTION FOR USE

Installation and use instructions:
1. Grounding method: Connected to the grounding metal parts of the equipment through the metal casing of the thermostat.
2. The thermostat shall be operated in a general indoor environment where the relative humidity of the air is not more than 90%, no corrosive gas, no flammable gas and conductive dust.
3. When the temperature controller is in contact with the temperature, the cover should be placed close to the heat-generating part of the controlled appliance, and the thermal surface of the cover should be coated with thermal grease or other similar heat-conducting medium.
4. When the temperature controller is exposed to liquid or steam, it is recommended to use a stainless steel cover and a reliable leak-proof measure to prevent liquid from seeping into the insulation of the thermostat.
5. It is not possible to collapse or deform the top of the cover to avoid changes in operating temperature or other properties.
6. Do not allow liquid to penetrate inside the thermostat! The housing must be protected from excessive forces to prevent cracking; the housing should be kept clean to prevent contamination of conductive materials to prevent short-circuit breakdown due to reduced insulation.
7. The terminal cannot be bent during use, otherwise the reliability of the electrical connection will be affected.
 

Previous
Next